OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3576

Stack Differential Pressure Sensor Circuit

U3576 is set when the stack differential pressure sensor delivers no signal, a shorted one or one outside its valid range. The title leaves open which two pressures it compares. In a GM patent such a sensor is plumbed between anode and cathode side, as the anode is normally kept slightly above the cathode. GM also uses it ahead of start-up, with the cathode still at ambient pressure, to verify the anode pressure sensor: ambient plus differential reading should match the anode value. Ford keeps the difference across the membrane within a tolerance of around 600 mbar, may shut the system down when it is breached and heats such sensors so that ice cannot blind them. No maker documents U3576 publicly. Expect a warning, reduced power or no start; anode inlet pressure is U3566/U3567.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 76

Possible causes

  • Open, short or corrosion in wiring or connector of the differential pressure sensor high
  • Water or ice in the sensor ports or a failed sensor heater medium
  • Differential pressure sensor faulty internally medium

Symptoms

  • Fuel cell system warning, MIL on
  • Reduced power or fuel cell system shuts down
  • No start, especially after a cold night

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U3576

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication