OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3574

Coolant Mixing Valve

U3574 serves as the catch-all for the coolant mixing valve when the trouble lies in its behaviour rather than its wiring: it sticks, moves too slowly or misses the commanded split between radiator and bypass. Temperatures reveal it, because GM sets stack outlet temperature with this valve and the inlet-to-outlet difference with pump speed, so a jammed valve upsets both. Toyota plans for the case: before each start the valve runs to a fully open end position to reset its zero point, and in one variant it is left open toward the radiator at shutdown, so a valve that seizes later still cools the stack. Hyundai patented a lower-friction plunger seal for its stack coolant valve against leaks and wear. No maker documents U3574 publicly. Expect a warning, swinging temperatures and less power.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 74

Possible causes

  • Valve element sticking from deposits, worn seal or unsuitable coolant medium
  • Actuator gear or motor worn, valve moves sluggishly medium
  • Internal leak, coolant passes the closed port low
  • Air in the stack coolant loop after service distorting the temperature response low

Symptoms

  • Fuel cell system warning, MIL on
  • Stack temperature swings or stays too high under load
  • Reduced power, slow warm-up in cold weather

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U3574

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication