U3573
Coolant Mixing Valve Control Circuit
U3573 concerns how the coolant mixing valve is powered: its actuator line may be interrupted or shorted, or the output stage may have failed. This three-way valve splits stack coolant between radiator and bypass and so decides how warm it is when it returns to the stack. Designs vary: in a Hyundai application a solenoid pushes a spool and its current sets the split, while Toyota describes a rotary valve turned by a stepper motor through a gear train. In the conventional Hyundai layout the valve takes the stack inlet temperature over CAN from the fuel cell control unit. If the actuator cannot be powered, coolant temperature is no longer regulated. U3573 appears in no public maker document. Likely consequences are a warning and capped output; how the valve itself responds is judged under U3574.
Possible causes
- Open, short or corrosion in wiring or connector of the valve actuator high
- Actuator motor or solenoid coil of the mixing valve faulty medium
- Driver stage or CAN link of the controlling unit faulty low
Symptoms
- Fuel cell system warning, MIL on
- Stack temperature too high or too low, reduced power
- Slow warm-up of the fuel cell system
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U3573
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.