OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3571

Stack Outlet Coolant Temperature Sensor 1 Circuit

U3571 concerns the wiring and signal of sensor 1 in the coolant stream leaving the stack. Coolant is hottest here, so the reading serves as the main overheat guard: GM holds stack outlet temperature mainly with a three-port valve sending coolant past or through the radiator and shuts the stack off when coolant at this point gets too hot. A wrong outlet value can therefore force a needless shutdown or hide genuine overheating. GM cross-checks the sensor against end cell temperatures and treats it as suspect when it reads more than 3 °C above their average. Hyundai can fall back on the exhaust temperature of the air side as a stand-in. No public maker document names U3571. Warning and lower output follow; U3572 covers sensor 2 at this location, U3570 the inlet.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 71

Possible causes

  • Open, short or corrosion in wiring or connector of outlet sensor 1 high
  • Outlet temperature sensor 1 faulty internally or drifting medium
  • Connector or wiring near the hot outlet line damaged by heat low

Symptoms

  • Fuel cell system warning, MIL on
  • Power reduced or fuel cell system switched off as a precaution
  • Outlet temperatures of sensor 1 and sensor 2 disagree in live data

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U3571

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication