OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3570

Stack Inlet Coolant Temperature Sensor Circuit

U3570 signals that the sensor for coolant entering the stack sends a broken, shorted or out-of-range reading. Thermal control is steered by this value: Hyundai describes a three-port valve which gets the stack inlet temperature from the fuel cell control unit over CAN and sets its opening from it, and in a Nissan patent the current drawn from the stack is capped once inlet coolant passes a set point, so that the outlet cannot overheat. GM shows that the inlet figure can also be estimated from pump inlet temperature, flow rate and a heat exchanger model. No maker documents U3570 publicly. Without a valid reading the system has to run on a substitute; a warning lamp and held-back power are to be expected. Outlet sensors report as U3571 and U3572.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 70

Possible causes

  • Open, short or corrosion in wiring or connector of the inlet sensor high
  • Inlet coolant temperature sensor faulty internally (drift, internal open) medium
  • Coolant seeping past the sensor seal into the connector low
  • Input stage of the fuel cell control unit faulty low

Symptoms

  • Fuel cell system warning, MIL on
  • Reduced power, especially under high load
  • Implausible stack inlet temperature in live data

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U3570

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication