U356F
Anode Header Drain Valve Heater Relay Control Circuit
U356F reports that the relay feeding the heater on the anode header drain valve cannot be driven properly because its coil circuit is open or shorted. That valve hangs on the stack's anode outlet header, where condensate gathers and can freeze during a cold soak. GM targets exactly this zone with heated outlet manifolds so ice does not block them during subzero starts. Whether the header valve carries its own heater and when it is switched is not described in public maker documents; the code only implies a relay separate from the one for the sump drain valve (U356E). Such a fault can leave the heater dead, risking an iced valve and a delayed or failed cold start, or keep it powered, which costs battery energy. In warm weather the effect is rarely noticeable. U356F has no public manufacturer source.
Possible causes
- Open, short or corrosion in the relay coil wiring or connector high
- Heater relay faulty medium
- Relay driver in the fuel cell control unit faulty low
Symptoms
- Fuel cell warning message
- Start problems after a frosty night
- Battery discharged if the heater stays on
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U356F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.