U356D
Anode Header Drain Valve
U356D is set when the header drain valve responds electrically yet does not empty the header as intended. GM splits each opening into two phases: first water runs out of the header, then nitrogen-rich gas is bled off. The end of the water phase is recognised from stack voltage or from an estimated gas flow across the valve, and the bleed phase is sized by the hydrogen content of the anode. If the water phase takes unusually long, GM concludes the stack is tilted or the header overfilled and calls on the valve more often. A valve stuck closed lets water build up and starve the cells farthest along the header; one stuck open keeps venting hydrogen into the cathode exhaust. Ice is a further risk at outlet manifolds. No maker publishes U356D. A warning and less power follow; circuit faults are U356C.
Possible causes
- Header drain valve or its line frozen medium
- Valve sticking or leaking from deposits or a worn seat medium
- Header drain line to the cathode exhaust blocked low
Symptoms
- Fuel cell system warning, MIL on
- Reduced power, uneven cell voltages
- Higher hydrogen consumption if the valve stays open
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U356D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.