OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U356C

Anode Header Drain Valve Control Circuit

U356C covers the drive circuit of a second drain valve mounted directly on the anode exhaust header, the channel inside the stack that gathers the gas leaving every cell. GM lists three valves behind the stack: a bleed valve at the top of the anode sump, a drain valve at its bottom and this header valve, which empties into the cathode exhaust. Condensate pooling in the outlet header harms cell durability, above all when the car stands on a steep slope, and GM has also patented heating of these manifolds against ice. Older logic opened the header valve only at shutdown or on a tilt sensor signal; GM's newer scheme lets it serve a share of bleed requests, by default the fifth. If the drive is open or shorted, the water stays put. No maker documents U356C publicly; a warning and limited operation are likely. The sump drain circuit is U356A.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 6C

Possible causes

  • Open, short or corrosion in wiring or connector of the header drain valve high
  • Valve solenoid coil open or shorted medium
  • Driver stage of the fuel cell control unit faulty low

Symptoms

  • Fuel cell system warning, MIL on
  • Power limited, especially after parking on a slope
  • Often no noticeable effect at first

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U356C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication