OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U356B

Anode Drain Valve

U356B is about how the drain valve behaves, not its wiring. Hyundai shows how such faults are separated: if the level in the trap fails to drop within a set time after an open command while the position sensor still reports closed, the valve is judged stuck shut; the system then limits current, drains on a schedule derived from accumulated charge and runs the stack warmer so water leaves as vapour. If the level stays low after a close command and the sensor reports open, hydrogen could escape, so the system is shut down. A dead level sensor can mimic a jammed valve; another Hyundai patent forces the valve open and watches whether a sagging cell voltage recovers to tell the two apart. In winter frozen condensate is a likely cause. No public source cites U356B; expect a warning plus reduced power or a shutdown.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 6B

Possible causes

  • Drain valve frozen after parking in frost medium
  • Valve sticking or not sealing due to deposits or a worn seat medium
  • Water level sensor of the trap faulty, valve itself fine medium
  • Drain line downstream of the valve blocked or iced low

Symptoms

  • Fuel cell system warning, MIL on
  • Power limited, fuel cell running hotter than usual
  • System shutdown if the valve stays open

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U356B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication