OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U356A

Anode Drain Valve Control Circuit

U356A concerns the electrical drive of the solenoid sitting under the anode water trap, which lets condensate leave the hydrogen loop. Hyundai opens it when a level sensor reports a full trap and closes it at a low mark so no hydrogen follows; if that sensor fails, the valve is closed as soon as anode pressure falls faster than a set rate. GM also gives the drain valve an emergency role: after an injector sticks open, hydrogen may be let out through it until the concentration in the exhaust reaches a limit. A broken or shorted drive circuit takes away both jobs. No maker documents U356A publicly. Since water keeps collecting in the anode, a warning and reduced or interrupted operation are plausible. The valve's mechanical state is U356B, the header drain circuit U356C.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 6A

Possible causes

  • Open, short or corrosion in wiring or connector of the drain valve high
  • Drain valve solenoid coil open or shorted medium
  • Driver stage of the fuel cell control unit faulty low

Symptoms

  • Fuel cell system warning, MIL on
  • Reduced power after some driving time
  • Fuel cell system shuts down

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U356A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication