OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3567

Anode Inlet Pressure Sensor 2 Circuit

U3567 belongs to the second pressure sensor at the anode inlet. Its signal carries safety weight: GM uses anode pressure to catch an injector stuck open, then shuts the tank valves, opens the anode bleed valve, lifts cathode pressure with compressor and backpressure valve and opens the cathode bypass so hydrogen in the exhaust stays diluted. Another GM patent treats a gap of more than a calibrated margin, typically 3 kPa, between actual and desired pressure as an injector fault. Sensors in this wet zone can ice up, so GM checks the anode sensor before start against ambient pressure plus the anode-to-cathode differential. A second sensor allows a similar comparison while driving. No maker publishes U3567. Expect a warning; with sensor 1 as the only source, power may be reduced. Sensor 1 is U3566.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 67

Possible causes

  • Open, short or corrosion in wiring or connector of sensor 2 at the stack high
  • Anode inlet pressure sensor 2 faulty internally medium
  • Water in the connector, fault mainly after frost low

Symptoms

  • Fuel cell system warning, MIL on
  • Often no noticeable change while sensor 1 still works
  • Reduced power

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U3567

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication