U3566
Anode Inlet Pressure Sensor 1 Circuit
U3566 is set for an electrical fault at anode inlet pressure sensor 1, sitting between hydrogen injector and stack. A GM patent explains why this value is central: it closes the loop for the injector and also feeds anode valve control and the handling of hydrogen in the exhaust. A wrong value derails that loop; in GM's example the injector is held at full duty because a 200 kPa target never shows on a sensor stuck at 100 kPa. GM flags such a sensor when its readings vary by less than 6 kPa over a time window and then runs the anode open loop, about 50 kPa above cathode pressure. Hyundai checks its stack supply pressure sensor against recirculation blower speed and warns in the cluster. As a circuit code U3566 covers opens and shorts; no public source uses it. Expect a warning and reduced power.
Possible causes
- Open, short or corrosion in wiring or connector of sensor 1 at the stack high
- Anode inlet pressure sensor 1 faulty internally medium
- Shared 5 V supply or ground faulty (often with other sensor codes) low
Symptoms
- Fuel cell system warning, MIL on
- Noticeably reduced power
- Rough or interrupted fuel cell start
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U3566
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.