U3565
Hydrogen Supply Line A Pressure Sensor 2 Circuit
U3565 signals that the second pressure sensor of hydrogen supply line A has a wiring problem. Two sensors on one line let the controller cross-check them, and Hyundai's Nexo shows how such a pair is handled in service: when hydrogen pressure sensor 1 or 2 (P315200, P315300) set codes, campaign T4E from 2019 had both swapped for a revised part at an outdoor venting spot, followed by an offset reset and a leak test; the thin metal membrane of the sensors must touch nothing. A later Hyundai update (20-01-029H) reworked the MIL logic in the Nexo's fuel cell controller and names the sensor 1 code P315292 in that context. No maker documents U3565. A warning is likely; relying on sensor 1 alone, the system may keep running, perhaps with less power. Sensor 1 on this line is U3564.
Possible causes
- Open, short or corrosion in wiring or connector of pressure sensor 2 high
- Pressure sensor 2 faulty internally medium
- Sensor membrane damaged during a previous repair low
- Fuel cell control unit faulty or needing a software update low
Symptoms
- Fuel cell system warning, MIL on
- Often no noticeable change while sensor 1 still works
- Reduced power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U3565
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.