U3564
Hydrogen Supply Line A Pressure Sensor 1 Circuit
U3564 deals with the wiring of pressure sensor 1 on hydrogen supply line A, most likely the medium-pressure section behind the tank regulator; J2012 does not fix the spot. Toyota's patent shows such a layout: a mechanical reducing valve brings tank hydrogen down to roughly 1.1–1.6 MPa, an intermediate pressure sensor watches that section, and the injector then lowers the pressure to about 200–300 kPa for the stack. To find an offset, Toyota closes the tank valve, lets the injector draw the line down until the reducer stands wide open, and compares readings up- and downstream of it. Hyundai's Nexo has two hydrogen pressure sensors, numbered 1 and 2, with their own codes (P315200/P315300) and renewed both in campaign T4E; U3564 itself is in no public document. Without the value, regulator monitoring suffers and power may be limited.
Possible causes
- Open, short or corrosion in wiring or connector of pressure sensor 1 high
- Pressure sensor 1 faulty internally (maker may supply a revised part) medium
- 5 V supply or ground of the sensor missing low
- Fuel cell control unit faulty or needing a software update low
Symptoms
- Fuel cell system warning, MIL on
- Reduced power
- Fuel cell system may refuse to start
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U3564
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.