U3563
Cathode Bypass Valve Position Sensor Circuit
U3563 means the position sensor on the cathode bypass valve delivers no usable signal because of a broken wire, a short or a voltage outside its window. Toyota's patent mounts such a valve body position sensor right at the bypass valve, with pressure sensors before and after it; the angle tells the controller how the compressor air is really being split between stack and bypass. A Hydrogenics patent likewise fits angle sensors to the throttle-type valves of its stack. No public manufacturer source names U3563. Without the feedback, the controller has to infer the valve state indirectly, for example from compressor outlet pressure or stack current as Toyota describes, and will usually restrict operation. Drive faults of the valve are U3561, a mechanically misbehaving valve U3562.
Possible causes
- Open, short or moisture in the position sensor wiring or connector high
- Position sensor in the valve unit faulty medium
- Shared 5 V supply or ground faulty (often with other sensor codes) low
Symptoms
- Fuel cell system warning, MIL on
- Reduced power, especially at low load
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U3563
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.