U3562
Cathode Bypass Valve
Unlike U3561, this code concerns how the cathode bypass valve itself behaves: it does not reach or hold the opening the controller asks for, for instance because it sticks. A Toyota patent shows why a valve stuck shut is serious. While a cold stack is warmed by deliberately inefficient generation, bypass air is supposed to thin out hydrogen in the exhaust; if ice holds the valve closed, all of that air enters the stack, which then produces more power than intended. Toyota spots this from compressor outlet pressure above a limit or from stack current straying from its command, then opens the backpressure valve and slows the compressor. A valve stuck open costs stack pressure instead, as Nissan notes. No maker publishes U3562; that stuck air valves switch on the MIL is documented by Toyota for the Mirai (T-SB-0043-23).
Possible causes
- Valve frozen in place after a cold soak medium
- Valve sticking from deposits or wear medium
- Actuator too weak or gear damaged medium
- Position feedback reading wrong, valve itself fine low
Symptoms
- Fuel cell system warning, MIL on
- Reduced power or failed start in frost
- Unusual compressor or air noise
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U3562
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.