OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3560

Cathode Backpressure Valve Position Sensor Circuit

U3560 is set when the signal of the position sensor on the cathode backpressure valve is missing, shorted or outside its electrical range. Outlet valves of this kind are often throttle flaps whose angle is reported back, as a Hydrogenics patent shows for the cathode and purge valves of a stack. The reading matters beyond the valve: in a GM patent the controller turns the valve position into an expected air-side pressure and compares it with the measured one to reveal leaks or blockages in the air path, so without a believable angle that check loses its footing. No manufacturer publishes U3560. The controller may carry on regulating from pressure alone or park the flap in a safe position; a warning and limited output are likely. Faults in powering the same valve are logged as U355F.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 60

Possible causes

  • Open, short or moisture in the position sensor wiring or connector high
  • Position sensor faulty (often only available with the valve unit) medium
  • Sensor 5 V supply or ground missing low

Symptoms

  • Fuel cell system warning, MIL on
  • Reduced power
  • Further air path codes stored at the same time

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U3560

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication