OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U355F

Cathode Backpressure Valve Control Circuit

U355F reports a wiring or output stage fault on the actuator of the valve at the cathode outlet, which throttles the air leaving the stack and thereby sets the pressure the air side runs at. GM moves such a valve in closed loop on a pressure reading, in steps or continuously. U355F itself is absent from public maker documents. For the 2021–22 Mirai, Toyota bulletin T-SB-0043-23 ties a lit MIL to a stuck air pressure regulating valve (P1F6E71), fixed by new EV control software or, since the 2025 revision, a new valve. In a Toyota patent air pressure that repeatedly exceeds about 270 kPa counts as a fault: compressor stopped, air routed into the bypass, valve opened. An open or shorted drive leaves cathode pressure uncontrolled; expect a warning and cut power. Position feedback has its own code, U3560.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 5F

Possible causes

  • Open, short or corrosion in wiring or connector of the valve actuator (wet exhaust area) high
  • Valve motor or actuator winding faulty medium
  • Driver stage of the fuel cell control unit faulty or software outdated low

Symptoms

  • Fuel cell system warning, MIL on
  • Noticeably reduced power
  • Fuel cell system shuts down or vehicle does not reach READY

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U355F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication