U355E
Expander Inlet Pressure Sensor 2 Circuit
U355E names a circuit fault on pressure sensor 2 at the expander inlet. Conditions there are harsh: cathode exhaust carries the product water of the stack, and Volkswagen notes in a turbine patent that the pressure drop inside the turbine makes water condense even behind a droplet separator, eroding the blades. A Hannover study on fuel cell turbines likewise asks for robustness against droplets and lets the turbine set the cathode operating pressure. Ford describes how wet pressure sensors in a fuel cell can freeze and give no or false signals at a cold start. A second sensor lets the controller spot such a reading. No maker documents U355E publicly. A failure of sensor 2 alone mainly removes this cross-check; together with U355D the expander control is blind and power is likely limited.
Possible causes
- Wiring or connector of sensor 2 corroded by exhaust moisture, open or shorted high
- Water frozen in the sensor port at cold start medium
- Expander inlet pressure sensor 2 faulty internally medium
Symptoms
- Fuel cell system warning, MIL on
- Fault appears mainly after cold starts
- Reduced power if sensor 1 is affected as well
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U355E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.