U355D
Expander Inlet Pressure Sensor 1 Circuit
U355D covers the first pressure sensor in front of the expander, a turbine in the cathode exhaust that turns leftover pressure from the stack outlet into shaft power for the compressor. Garrett states that its optional turbine expander, developed among others for the compressor of the BMW iX5 Hydrogen, lowers the electricity needed for compression by up to 20 %. In a Toyota patent a waste gate valve divides exhaust between turbine and bypass, because the flow resistance of the turbine raises the pressure the compressor must supply and can push it toward surge. A sensor at the turbine inlet shows this back pressure directly. No maker documents U355D. Losing it takes an input from energy recovery and cathode pressure control. Toyota's Mirai bulletin T-SB-0043-23 shows that faults on the cathode air side light the MIL.
Possible causes
- Wiring or connector of sensor 1 at the wet exhaust side corroded, open or shorted high
- Expander inlet pressure sensor 1 faulty internally medium
- Sensor supply or ground faulty low
Symptoms
- Fuel cell system warning, MIL on
- Higher hydrogen consumption because less energy is recovered
- Reduced peak power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U355D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.