OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U355C

Charge Air Cooler Outlet Temperature Sensor Circuit

U355C reports a circuit fault on the temperature sensor behind the charge air cooler. Compression heats the air strongly: Honda gives about 120 °C at the compressor outlet, while the stack works at 80 to 90 °C, so the air is first brought down to roughly 60 to 75 °C. The sensor confirms this cooling before the air reaches the humidifier. In a Toyota patent it sits between intercooler and humidifier, and if the intercooler coolant pump fails, the controller slows the compressor to keep air temperature below a set limit; Nissan derives an upper pressure limit from the same reading. No maker documents U355C publicly. Without a valid temperature, humidifier and membrane lose their protection, so a warning and a careful cut in power should follow. Pressure here is U355A/U355B.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 5C

Possible causes

  • Open or short in wiring or connector of the temperature sensor high
  • Temperature sensor (thermistor) faulty internally medium
  • Sensor ground or reference circuit faulty low

Symptoms

  • Fuel cell system warning, MIL on
  • Power limited, especially under sustained high load
  • Compressor runs at reduced speed

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U355C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication