U3548
High Voltage System Interlock Circuit P High
U3548 is the high-side code of loop P. When each unit adds a known share of loop resistance, a single suspect can be isolated by substitution. Tesla's Model S HVIL guide has technicians, after consulting a field engineer, place a 60-ohm resistor across the drive inverter's interlock pins at connector X250 and also bridge its CAN lines; if the contactors then close, the inverter's internal section is to blame. Such a stand-in serves only as a short test by trained staff and must be removed afterwards. No maker documents U3548. A raised reading calls for measuring the share of each component on loop P.
Possible causes
- Internal interlock section of an HV component too resistive medium
- Loop P wire shorted to a 12 V feed medium
- Loose or poorly crimped interlock terminal in loop P medium
Symptoms
- Contactors stay open, no ready mode
- High-voltage system warning
- Charging blocked
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U3548
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.