U3546
High Voltage System Interlock Circuit P Performance
U3546 marks loop P as implausible. On large vehicles the mechanical routing of HV cables affects the interlock too. Gillig's field service campaign FSC 22-13-2479 for its Gen 2.0 and 2.5 battery electric buses found that HV battery cables in one equipment compartment lacked adequate support brackets; the outcome was an intermittent HVIL fault 8175, sometimes with the HV exposure lamp lit, and the fix was added bracketry. A heavy cable that swings with every bump can tug at its plug just enough to upset the loop for an instant. No maker documents U3546. Look for unsupported cable runs close to the plugs of loop P.
Possible causes
- HV cable without adequate brackets pulling on a loop P plug high
- Loose contact in a loop P connector medium
- Cable clamp or bracket not refitted after repair low
Symptoms
- Interlock fault that comes and goes, more often on rough roads
- High-voltage warning lamp lighting briefly
- Brief loss of high-voltage power
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U3546
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.