U3544
High Voltage System Interlock Circuit O High
U3544 sets when loop O delivers too high a value. A plug can hold its specified torque and still sit crooked. FCA's STAR case S2108000121 (Rev. B, 2026) for Wrangler and Grand Cherokee 4xe models describes P0A0A after HV repairs although the connector bolts reached 9 Nm: the plug had gone on at an angle, the C3 connector of the power inverter module in particular. Three windows around its shield must show bare aluminium housing with no gap; spread interlock terminals mean replacing the HV component. In a current-fed loop such poor contact appears as a higher value. No maker documents U3544. Seat each plug squarely before tightening.
Possible causes
- HV plug on loop O torqued down while tilted high
- Interlock terminals spread by a crooked fitting medium
- Loop O wire shorted to a 12 V feed medium
- Connector bolt thread stripped so the plug cannot be clamped low
Symptoms
- Check engine light and hybrid system message right after an HV repair
- No ready mode
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U3544
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.