OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U353F

High Voltage System Interlock Circuit N Low

U353F covers a loop N value under the permitted minimum. The defect can sit inside a consumer rather than in the harness. For the Cummins battery electric systems BES CM2450 EV110B and EV111B, bulletin TSB250044 ties fault codes 8174 (interlock level too low or grounded) and 8175 to the electric air compressor: once the interlock contacts of the HV cable to the compressor pass, the measurement moves to the interlock pins of its low-voltage connector, and above 2 ohms (1 ohm in the first issue of February 2025) the compressor gets replaced. No maker documents U353F. While it is set, the vehicle is likely to lose high-voltage readiness.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 3F

Possible causes

  • Interlock path inside an HV consumer such as an electric air compressor open or high-resistance high
  • HV cable plug on loop N not reconnected properly medium
  • Loop N wire shorted to ground medium

Symptoms

  • High voltage switches off and stays off
  • Interlock fault returns although all cable plugs test fine
  • Auxiliary drive such as the air compressor not running

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U353F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication