U353D
High Voltage System Interlock Circuit N
U353D is the general code for interlock circuit N, the thirteenth loop in J2012 lettering; designs with that many loops are only conceivable on very large high-voltage systems. No maker documents U353D publicly. Moisture is a frequent root cause on interlocks of any letter: FCA bulletin 08-131-21 for the 2021 Jeep Wrangler plug-in hybrid traces a no-start with P0A0A to water getting past a pinched orange seal into the P1 and P2 HV connectors under the car, often logged together with an isolation fault (P0AA6). Where corrosion has set in, the harness or the power inverter module has to be replaced. Inspect seals before cleaning pins.
Possible causes
- Water in a loop N connector because a seal is pinched or damaged high
- Connector in loop N not fully seated medium
- Interlock pins corroded after earlier moisture medium
- Controller that drives and reads loop N faulty low
Symptoms
- No ready mode or no start, often after rain, washing or wading
- Isolation fault stored alongside the interlock code
- Hybrid or high-voltage system warning in the cluster
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U353D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.