U3532
High Voltage System Interlock Circuit K Performance
U3532 indicates that loop K does not respond the way the controller expects. Some checks run only while the system powers up. A Ford patent describes one: during precharge a switch holds the high-voltage bus between an upper and a lower level far below operating voltage, and the interlock test takes place inside that window. Too little current then suggests a connector that is not seated, too much a short, and only a passed test lets precharge carry on. A start-only test of this kind can let a marginal contact pass on one key cycle and fail on the next, so the code may come and go between trips. No maker publishes U3532. Expect occasional refusals to become ready.
Possible causes
- Marginal contact in a loop K connector that passes some start checks and fails others high
- Fault in the precharge path disturbing the start-up check low
- Controller software with outdated check limits low
Symptoms
- Vehicle sometimes does not become ready at switch-on, then works on the next attempt
- Fault stored at start-up rather than while driving
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U3532
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.