U3531
High Voltage System Interlock Circuit K
U3531 stands for an unspecified fault on interlock circuit K, the tenth loop. An interlock need not be a dedicated wire pair. For hybrid trucks, International patented running the hybrid CAN bus through the same connector as the power cable: once the plug is parted, data traffic on that bus stops and one terminating impedance drops out, and a traffic detector then opens an interrupter in the high-voltage feed. A loop K built along these lines would react to a dead or disturbed bus section as well as to an open plug, so network faults stored in the same controllers deserve attention. No maker discloses the members of loop K. High voltage stays blocked while the fault is active.
Possible causes
- Connector in loop K not fully latched high
- Communication line routed with loop K interrupted or disturbed medium
- Loop K wiring damaged medium
- Controller monitoring loop K faulty low
Symptoms
- No ready mode or one high-voltage branch unavailable
- Network or communication codes stored alongside
- High-voltage system warning in the instrument cluster
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U3531
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.