U3530
High Voltage System Interlock Circuit J High
U3530 flags loop J above its upper threshold. Foreign voltage is one explanation, but in a design that pushes a constant current through the loop and reads the drop across it, any added resistance lifts the measured value too. Tesla's HVIL tech note for early Model S cars, filed with NHTSA, names a poor solder joint at a charger board connector that exceeded 90 ohms only when hot. To reproduce it, technicians drove about 20 minutes at highway speed, charged for at least half an hour and measured the loop pins on the still warm charger. A loop J fault that turns up only after long trips or charging sessions points to such heat-sensitive joints. No maker documents U3530 itself.
Possible causes
- Cracked solder joint or crimp in loop J whose resistance rises when warm medium
- Loop J wire in contact with a 12 V supply medium
- Loose or spread terminal in a loop J connector medium
Symptoms
- Fault appears after long drives or charging, not on a cold start
- Charging session or drive interrupted by a high-voltage warning
- Loop measures normal once the components have cooled down
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U3530
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.