U352D
High Voltage System Interlock Circuit J
U352D is the summary code for interlock circuit J, the ninth loop in J2012 lettering, which leaves out the letter I. What the loop contains is up to the maker, and none has published it. A loop need not pass through plugs only: a Ford patent for a centralised interlock leads the circuit across mating body parts such as the hood or trunk latch and its receptacle, so that opening the lid by itself switches high voltage off; floor access panels are named as a further option. Where a design like this is used, a lid that has not fully latched can explain a fault on loop J. Check latches before wiring; the vehicle cannot become ready until the loop is complete.
Possible causes
- Connector in loop J not fully latched high
- Hood, trunk or access panel latch wired into loop J not fully engaged medium
- Loop J wiring damaged medium
- Controller that drives and reads loop J faulty low
Symptoms
- No ready mode, often right after a hood, trunk or underbody panel was opened
- High-voltage system warning in the instrument cluster
- Charging blocked
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U352D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.