U352C
High Voltage System Interlock Circuit H High
U352C reports an excessive reading on loop H. Whether that points to foreign voltage or to a break depends on the quantity the controller evaluates. If it reads voltage, a wire touching 12 V is the usual reason. If it works out the loop's resistance, as Lear's tester patent does, a value beyond the maximum is treated as open and one under the minimum as shorted, so high may mean corrosion or a loose terminal. The service data of the specific vehicle settles which reading applies; for U352C no maker publishes it. Measure loop H resistance with every plug latched and compare it with a sound loop of the same vehicle.
Possible causes
- Loop H wire in contact with a 12 V supply medium
- Corroded or loose terminal raising loop H resistance medium
- Loop source stuck on in the controller low
Symptoms
- No ready mode, high-voltage warning
- Fault sometimes disappears after moving connectors
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U352C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.