U3528
High Voltage System Interlock Circuit G High
U3528 means something lifts loop G to a level the controller never expects from it. Texas Instruments notes that automotive interlocks, unlike industrial ones, must survive a short to the 12 V battery and to ground; its reference design feeds the loop through an intelligent switch on the supply side with current limiting and thermal shutdown. Such electronics may come through a short undamaged, whereas a simpler output stage can fail, and then the code returns even after the wiring is repaired because the driver now stays on. No manufacturer documents U3528. Remove the foreign voltage, clear the code and test again before replacing a controller.
Possible causes
- Loop G wire shorted to the 12 V supply high
- Loop output stage damaged by an earlier short and stuck on medium
- Moisture bridging pins in a loop G connector low
Symptoms
- No ready mode, high-voltage warning
- Code persists after the harness repair
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U3528
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.