U351E
High Voltage System Interlock Circuit E Performance
U351E points to loop E giving results the module cannot trust, and the doubt may concern the monitoring hardware as much as the wiring. Designers do test their own test circuits: CATL first checks its current-generating stage so that a failing source is not blamed on high-voltage parts, and Sanden's interlock at the plug of an electric A/C compressor also recognises defects of the monitoring device and its loop, not only an unplugged connector. A performance code on loop E can therefore come from a drifting source or detector. No maker publishes U351E. Once wiring and plugs test fine, suspect the controller running the loop.
Possible causes
- Current or voltage source for loop E drifting in the controller medium
- Loose contact in a loop E connector medium
- Detection circuit or its reference faulty medium
- Controller software with outdated plausibility limits low
Symptoms
- High-voltage shutdowns without a recognisable pattern
- Fault returns although wiring and connectors test good
- Possibly further self-test codes in the same controller
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U351E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.