U351C
High Voltage System Interlock Circuit D High
U351C is stored when loop D carries more voltage than its present state allows. GM's high check for loop A, P0A0D, shows why both states are tested: with the source commanded to 0 V, more than 24 % of 5 V counts as a failure, five times in eight samples; with the source at 5 V the limit is 44 %, four times in six. A loop that fails to fall when its source switches off reveals foreign voltage even if it looks normal while fed. No maker lists U351C. Likely are a loop wire touching a 12 V feed, a source that no longer turns off, or a bad repair splice. Readiness is withheld until the loop is clean.
Possible causes
- Loop D wire in contact with a 12 V supply line high
- Source driver in the controller no longer switches off medium
- Earlier repair splice joined the loop to a wrong wire low
Symptoms
- Vehicle does not reach ready mode
- Fault returns immediately after clearing
- Other 12 V consumers may show faults if a supply wire is involved
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U351C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.