OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U351B

High Voltage System Interlock Circuit D Low

U351B reports that too little level comes back from interlock loop D while the module drives it. GM's hybrid tables for the loop A code P0A0C give a frame of reference: the test only runs when on-board voltage exceeds 10.2 V, judges what fraction of a 5 V test signal returns against a 30 % limit and logs a Type A fault after two failed 12.5 ms readings. A weak 12 V battery thus pauses the check instead of tripping it. No maker publishes a calibration for U351B. Typical causes are a wire crushed against the body, a loop plug left off, or a dead source; the contactors behind loop D may not close.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 1B

Possible causes

  • Loop D wire pinched against the body and shorted to ground high
  • Plug within loop D not seated after a repair medium
  • Test voltage source in the controller failed low

Symptoms

  • No ready mode or high-voltage branch D unavailable
  • Warning to have the high-voltage system checked
  • Fault stays present after clearing until the wiring is repaired

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U351B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication