OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3514

High Voltage System Interlock Circuit B High

U3514 means loop B reads higher than allowed: a wire of the loop touches 12 V or another supply, or the loop does not fall back to its low state once the module turns its source off. GM's loop A code checks both states, allowing 24 % of 5 V while the source is off and 44 % while it is on. Ford's interlock patent tests the source line for a short to 12 V before releasing the loop, then stores a trouble code and turns on the Service Soon lamp rather than a general warning. In the reference design from Texas Instruments a short to battery shows up as loop current that no longer follows the commanded on/off pattern. No manufacturer lists U3514 itself. Disconnecting segments one at a time shows where the foreign voltage enters loop B.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 14

Possible causes

  • Interlock wire of loop B shorted to 12 V or another supply high
  • Interlock source in the module not switching off medium
  • Water in a connector bridging an interlock pin to a supply pin medium
  • Incorrect splice or add-on wiring after a repair low

Symptoms

  • Vehicle will not start or enter ready mode
  • Service or HV warning lamp on
  • Fault stays present with all HV connectors properly mated

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U3514

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication