OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3513

High Voltage System Interlock Circuit B Low

U3513 reports a signal on interlock loop B that stays below its lower limit while the loop is energised by the module. What that means depends on the circuit: where the module feeds a test voltage in and reads it back at the far end, an opened plug reads low just like a wire touching ground. GM's documented loop A gives a sense of scale: its low code sets when less than 30 % of its 5 V check voltage comes back in two 12.5 ms samples, Type A. Texas Instruments' reference design shows how a current-fed loop can tell both apart: a grounded wire makes the loop current vanish while the supply current rises, with an open loop both drop. No maker publishes U3513. The contactors stay open; check loop B for chafed wires and unplugged connectors.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 13

Possible causes

  • Interlock wire of loop B chafed through to ground high
  • Plug or cover in loop B open, read as low by the sensing circuit medium
  • Pushed-back interlock terminal without contact medium
  • Interlock source in the monitoring module not delivering its signal low

Symptoms

  • No ready mode, HV contactors stay open
  • Hybrid or EV warning lamp, MIL depending on maker
  • Charging not possible

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U3513

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication