OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3510

Control Module Missing Calibration

U3510 says a control module lacks a calibration it needs: either the data set that adapts its software to the vehicle was never written or got lost, or a learned calibration such as a sensor alignment has not been done. CARB makes every emission-critical unit report a calibration ID and a verification number, so empty or invalid data cannot pass unnoticed. No maker publishes U3510 itself, but related codes show both meanings: Hyundai's chassis code C2702, worded the same way, appears on 2019 Elantra blind-spot radars (bulletin 19-BE-016H, new radar plus mounting-angle check), and Stellantis' C0529-00 for the steering angle sensor of the 2023 Dodge Hornet lit the MIL until the wheel was turned lock to lock (08-148-23, EPS update).

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number5 / 10

Possible causes

  • New or used module installed without programming or setup high
  • Software update aborted, e.g. by low 12 V voltage or lost connection medium
  • Required learn or alignment routine not performed after repair medium
  • Internal memory of the module losing its stored data low

Symptoms

  • Function of the affected module unavailable or limited
  • Warning lamp of the related system, MIL if the module is OBD-relevant
  • Fault appears right after a module replacement or software update

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U3510

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication