U3501
Control Module Input Power A Circuit Low
U3501 reports that supply A of a module is below its permitted range. GM's electric brake booster (BSC2) in the 2016–2019 hybrid OBD tables runs two checks: the CAN/logic supply under 7.5 V for 0.09 s, and the internal sensor for the module supply under 4.9 V for 0.2 s, a level below the point where the hardware should already have shut down. Both are Special Type C, so no MIL. The weight of the code lies elsewhere: GM lists U3501 among the conditions that suspend many other booster tests, because motor and sensor checks are meaningless without proper supply. It passes after 30 s with ignition on. Usual causes are a weak or discharged battery, a deep dip while cranking, a corroded fuse or terminal on the feed, or a bad ground.
Possible causes
- Weak or discharged 12 V battery high
- Deep voltage dip during engine start medium
- Corroded fuse, terminal or ground in the A feed medium
- Internal supply stage of the module faulty low
Symptoms
- Module resets or drops off the network at low voltage
- Other self-tests of the module suspended
- Warning lamp for the affected system, usually without MIL
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for U3501
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.