OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3035

Communication Authentication Signal Invalid Data

U3035 means a secured message arrived but its authentication part did not check out, so the receiver treats the content as invalid. In AUTOSAR Secure Onboard Communication the receiver recomputes the message authentication code over data ID, payload and freshness value; a mismatch or an unusable key counts as failed verification and the message is dropped. Ford's SSM 51497 for 2023 Super Duty says the PCM sets U3035 when authentication fails after key initialization, harmless without other codes, MIL or drivability issues; TSB 23-2421 reflashes the 6.8L/7.3L PCM when the MIL is on with P061B, U0140 and U3035/U3036. Audi's TSB 2077740 ties U303500 with U029400 and U012900 to Q6 e-tron that cannot select a gear in cold weather. Ford TRON module replacement without new keys also causes it.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 35

Possible causes

  • Module software rejecting valid messages, fixed by update high
  • Keys not aligned after a module replacement medium
  • Messages checked before key initialization or wake-up finished medium
  • Corrupted frames from wiring or bus faults low

Symptoms

  • Code found during a self-test without complaints
  • MIL with further network or processor codes on some engines
  • Function refused, e.g. gear selection not possible in the cold

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U3035

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication