OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3030

Ignition Output Start

U3030 points to the start output, the line through which a module energizes the starter relay or passes on a crank request; it should be active for seconds at most. In Tokai Rika's push-button start patents the power supply unit switches the starter relay on together with the ignition relays once brake pedal and button are confirmed, and off as soon as the engine controller reports that the engine has fired. Which unit owns this output varies: on GM's 2012 pickups the engine control module, not the body controller, drives the starter enable relay. A module logs U3030 when the line stays dead although cranking is commanded, leaving the engine unable to crank, or stays live after the command ends, which can keep the starter engaged. No manufacturer documents U3030 publicly; starter relay circuit faults have their own codes, P0615 to P0617.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 30

Possible causes

  • Faulty start driver in the module, not switching or stuck on medium
  • Start control wire open or shorted to ground or voltage medium
  • Open or shorted coil in the starter relay loading the output medium
  • Weak battery pulling the output level down during cranking low

Symptoms

  • Engine does not crank when start is requested
  • Starter keeps running or grinding after the engine has fired
  • Start only on a second or third attempt

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U3030

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication