OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U302E

Ignition Output On

U302E applies to an output intended to carry voltage in On alone, which means it has to switch off while the starter turns. The driving module must blank out that intended gap during cranking and judge the output only in steady power modes, otherwise every start would log the code. How such a check can be built is shown in Yazaki's patent CN106797120A: a controller measures the voltage behind a second ignition relay, treats a reading below a threshold set between nominal voltage and 0 V as a relay that failed open, warns the driver on a display and moves the affected loads over to the first ignition feed. Transferred to U302E, a dead output in On points to a relay stuck open, a blown fuse or a broken wire, while voltage in Off points to a welded contact or a driver stuck on. No manufacturer documents U302E publicly.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 2E

Possible causes

  • Run relay not closing, e.g. burnt contacts or open coil medium
  • Blown fuse or broken wire behind the relay medium
  • Welded contact or driver stuck on, leaving the output live in Off medium
  • Module software judging the intended cut during cranking as a fault low

Symptoms

  • Loads on the run-only feed dead with the engine running
  • Power supply warning in the cluster
  • Battery discharged when the output stays on after shut-off

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U302E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication