OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U302D

Ignition Output On/Start

U302D concerns the output that powers the On/Start circuits, i.e. everything that has to work with the engine running and through cranking but not in Off or Accessory. On GM's 2012 pickups the body control module handles this by switching the coil of the run/crank relay over circuit 5199. GM bulletin PIT5817A, covering 2020–2021 models such as Escalade, Tahoe, Corvette and CT5, shows what goes wrong on that side: the BCM keeps driving ignition main relay KR73 after shut-off, circuit 5199 stays live and the battery runs down, while engine, transmission and brake controllers store P2535 and the cluster stores U300D; the repair is a new BCM. GM records that case through input codes in the receivers, not as U302D. A module that checks its own on/start output would catch the same fault at the source. No manufacturer documents U302D publicly.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 2D

Possible causes

  • Relay driver in the body control module staying on after shut-off high
  • Ignition main relay contact welded or relay not pulling in medium
  • Relay coil control wire open or shorted to voltage medium
  • Retrofitted device feeding voltage back into the run/crank circuit low

Symptoms

  • Battery repeatedly flat, often after a remote start
  • Engine lamp at start-up with P2535 stored in engine and transmission modules
  • No start or modules without power if the output fails open

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U302D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication