OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U302B

Ignition Output Accessory/On/Start

U302B belongs to the ignition outputs, i.e. a feed that a module switches itself instead of merely reading it. The Accessory/On/Start variant should carry voltage in every power mode except Off and, unlike most accessory feeds, should stay on while the engine cranks. The driving unit, typically a body controller or the power supply unit of a keyless start system, compares its command with what it reads back on its own pin and stores U302B when the two differ: voltage in Off, or none in accessory, run or crank. No manufacturer documents U302B publicly. Tokai Rika's patent US6900552B2 shows such a unit switching separate relay coils for accessory, two ignition stages and the starter through FET drivers. A driver stuck on or a welded relay contact on this feed can flatten the battery overnight.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 2B

Possible causes

  • Welded relay contact keeping the feed live in Off medium
  • Faulty driver stage in the switching module, stuck on or not switching medium
  • Output wire or a connected load shorted to ground, tripping the driver protection medium
  • Blown fuse between the relay and the loads on this feed low

Symptoms

  • Battery flat after the car has been parked
  • Several loads on the feed dead although the vehicle is switched on
  • Warning about the power supply or ignition system in the cluster

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U302B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication