U3029
Control Module A Disable Feedback Circuit Low
U3029 narrows the feedback fault to a signal that stays below its valid range, typically a readback wire shorted to ground. The consequence follows from the readback idea in GM's patent US9122662B2, where the inhibit path is driven through known test states and its actual output compared with the expected one: if the feedback is pinned low, every state that should read high fails, and the monitor cannot tell a working shutdown from a broken one. Depending on the design, a permanently low readback may also be taken as module A already being disabled. No manufacturer documents U3029 publicly. The usual suspects are a chafed readback wire touching the body, water in a connector or a defective input stage; the disable line itself should be checked separately.
Possible causes
- Feedback wire shorted to body ground high
- Moisture or corrosion pulling the readback pin low medium
- Defective readback input stage in the monitoring module low
Symptoms
- Function of module A locked out, system warning displayed
- Code returns at every start until the short is found
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U3029
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.