U3028
Control Module A Disable Feedback Circuit
A disable line is only useful if someone can prove it works, so many designs read back what actually arrives at the switched module. U3028 reports a fault in that feedback path for module A: the returned signal is missing or does not match the state that was commanded. GM's patent US9122662B2 shows the principle: while the ignition is off, several processors set their outputs in a fixed series of test states and compare the resulting output of the inhibit path with the expected value, flagging a fault on any mismatch. FCA's patent US10676100B2 likewise steps through six combinations of shutoff signals. No manufacturer documents U3028 publicly. Unlike U3025, the shutdown line itself may be fine; the system just cannot confirm it, so it often withholds the function until a test passes.
Possible causes
- Open feedback wire or loose pin between module A and the monitoring module high
- Self-test disturbed by low voltage or an early shutdown medium
- Faulty readback stage in module A or the monitoring module low
Symptoms
- Function of module A blocked after the self-test, system warning
- Fault may appear only at start-up or shutdown
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U3028
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.