U3027
Control Module A Disable Circuit High
U3027 is the high-side counterpart: the disable line to module A reads above its valid range, as with a short to battery voltage or a neighbouring wire. In an active-low design such as the one in Siemens patent US7596436B2, where pulling the shutdown path to ground blocks the output stages, a line stuck high means module A keeps its enable and can no longer be switched off over the hard-wired path. That removes the independent safety layer FCA's patent US10676100B2 is built around, where losing a shutoff line could let a hybrid keep producing torque. Systems therefore treat this case strictly and usually disable the function by other means. No manufacturer documents U3027 publicly; check for a short to a powered wire in the harness and for water in connectors.
Possible causes
- Disable wire shorted to a battery or supply wire high
- Moisture or corrosion bridging pins in a connector medium
- Output driver of the supervising module stuck high low
Symptoms
- Function locked out by the safety concept, system warning shown
- Vehicle may not become ready to drive
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U3027
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.