OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3026

Control Module A Disable Circuit Low

U3026 is logged when the disable line to module A sits below its valid voltage range, typically because it is shorted to ground. What that means depends on the polarity the maker chose. In the Siemens control unit of patent US7596436B2 the enable signal is high for run and low for shutdown, and a monitoring circuit cuts the output stages by pulling the shutdown paths to vehicle ground. With such active-low logic a short to ground looks exactly like a permanent shutdown command, so module A stays off and the driver loses that function, although nothing else is wrong. Where low is the run state, the danger is the opposite, since the shutdown can no longer be signalled. No manufacturer documents U3026 publicly. Look for a chafed wire touching the body between the two modules.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 26

Possible causes

  • Disable wire chafed through and touching body ground high
  • Moisture in a connector creating a leak path to ground medium
  • Supervising module holding the line low permanently low

Symptoms

  • Module A stays switched off, function unavailable
  • Warning message for the affected system

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U3026

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication