OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3025

Control Module A Disable Circuit/Open

Safety-relevant systems often give a supervising controller a hard-wired line through which it can switch off another module or its power stage, independent of the bus. Bosch patent US6804564B2 describes a first control unit that de-energizes a faulty second unit over such an output line, and FCA patent US10676100B2 shows a hybrid where control processor, motor processor and a monitor each have their own shutoff line to the inverter gate driver. U3025 says this disable line to module A is open or electrically missing. No manufacturer documents U3025 publicly. A broken line is serious either way: depending on the logic, module A may treat it as a permanent shutdown request and refuse to run, or stopping it in an emergency becomes impossible, which is why the system usually keeps the function off.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 25

Possible causes

  • Broken disable wire or unplugged connector between the two modules high
  • Corroded or pushed-out pin on the disable line medium
  • Output driver of the supervising module no longer driving the line low
  • Input stage of module A misreading the line low

Symptoms

  • Function of module A unavailable, e.g. drive system not ready
  • System warning message in the cluster

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U3025

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication