OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3024

Control Module Input Power Circuit B - Ignition Input On/Start Circuit Correlation

U3024 is the same plausibility test as U3023, but against the module's second battery feed, B: with the key in run or start, feed B and the switched ignition input should show about the same voltage, and a lasting gap points to a fault on one of the two paths. The code only makes sense on modules with two permanent feeds plus an ignition line. No manufacturer documents U3024 publicly. For guidance, GM's 2025 tables describe the A variant in engine and transmission modules: battery present, run/crank active, starter not engaged, and a difference above 3 V in most of 50 samples. If only U3024 is stored and not U3023, feed B itself is the more likely culprit, since a missing ignition signal would upset both comparisons. Effects depend on what feed B powers inside the module.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 24

Possible causes

  • Blown fuse or damaged wire on battery feed B high
  • Run/crank relay or ignition wire delivering too little voltage medium
  • Loose or corroded pin for feed B in the module connector medium
  • Faulty voltage sensing inside the module low

Symptoms

  • Warning lamp or message, depending on the module
  • Loss of functions supplied through feed B

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U3024

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication